 | | Re: primer/tutorial on BFC?
|
|
(...) [snip] (...) I just wanted to add one more post in an attempt to clear up any confusion that may have been caused in this thread. What Andy says above is correct, and my earlier post indicating otherwise was incorrect. The two dimensional (...) (21 years ago, 4-Jan-04, to lugnet.cad.dev)
|
| |
| | Re: primer/tutorial on BFC?
|
|
(...) Hmmm, very good point. I don't like treating specific object specially, but I don't see any way around it. I played around with the stud and with a 'solid' cylinder object, I couldn't find a way to get L3Lab's BFC handling to fail. Steve (21 years ago, 4-Jan-04, to lugnet.cad.dev)
|
| |
| | Re: primer/tutorial on BFC?
|
|
(...) Actually, I *think* it's the new ATA controller card I installed, and LDView was just an innocent bystander. However, since LDView doesn't do BFC, I guess I didn't miss anything. (...) Yes, you could use INVERTNEXT, but that introduces (...) (21 years ago, 4-Jan-04, to lugnet.cad.dev)
|
| |
| | Proposed changes to MOTM Submission guidelines
|
|
After formal running the MOTM contest for a month, I've becomed concerned with the fairness of the contest. In response to my concerns, I'd like to make the following changes to the rules for MOTM in order to level the playing field. - All (...) (21 years ago, 4-Jan-04, to lugnet.cad, lugnet.cad.dev, lugnet.cad.dev.org.ldraw)
|
| |
| | Re: primer/tutorial on BFC?
|
|
(...) You're right; I'm wrong. I'm still having a hard time visualizing it, but your stud example below convinced me that negating the one value in the matrix will indeed flip a 2D primitive like a disk, and this is the expected behavior. In fact, (...) (21 years ago, 3-Jan-04, to lugnet.cad.dev)
|
