 | | Part Measurements and Authoring —Orion Pobursky
|
| | | A question for all part authors How do you figure out the measurements for your parts? I'm not talking about the obvious measurements such as stud width but the more intricate details on some of the more complex parts. Do you use a micrometer, (...) (22 years ago, 5-Mar-03, to lugnet.cad.dev)
|
| | | |
| | | | | Re: Part Measurements and Authoring —Chris Dee
|
| | | | | (...) If the region of the part interfaces with an existing part then I base it upon that. Although, feel free to challenge existing parts if they are incorrect. Otherwise I do use a micrometer or steel rule (Imperial dimensions - using 1/64 = (...) (22 years ago, 5-Mar-03, to lugnet.cad.dev)
|
| | | | | |
| | | | | Re: Part Measurements and Authoring —Lance Hopenwasser
|
| | | | "Orion Pobursky" <bilthefish@IHATESPAMyahoo.com> wrote in message news:HB9Itr.4zw@lugnet.com... (...) eyeball (...) Well, I've just started authoring parts, but I am rather fond of my calipers, especially for inside measurements. My set happens to (...) (22 years ago, 6-Mar-03, to lugnet.cad.dev)
|
| | | | |
