To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.devOpen lugnet.cad.dev in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / 8076
    question/problem with some flag parts —Jonathan Wilson
   Can someone explain why the "flag 6 x 4" and the "flat 6 x 4 with jolly roger pattern" are different sizes? Is this an error? (22 years ago, 12-Dec-02, to lugnet.cad.dev)
   
        Re: question/problem with some flag parts —Jaco van der Molen
   Hmm... The flag 6 x 4 (#43) is actually 6 x 3 1/3. Flag 6 x 4 (#43P01) is 6 x 4. Strange. I do not own any of these two parts, but I think part 43 is either mesured wrong or the description is wrong. Or part 43P01 is wrong... Jaco "Jonathan Wilson" (...) (22 years ago, 12-Dec-02, to lugnet.cad.dev)
   
        Re: question/problem with some flag parts —Bernd Broich
   You're right. The 43.dat isn't a 6 x 4 flag. But I can't tell you if there exists a real 6 x 3 1/3 one. The "Jolly Roger" one is named correct. Does anybody want to fix this? CU Bernd Jaco van der Molen <jmolen@globalxs.nl> schrieb im Newsbeitrag (...) (22 years ago, 12-Dec-02, to lugnet.cad.dev)
   
        Re: question/problem with some flag parts —Chris Dee
   (...) I'm pretty sure there is not a 6 x 3 1/3 flag, and seeing as the original author titled it "6 x 4" I suspect this was just an error in authoring (and review !). I'll liaise with the author to arrange a fix. Chris (22 years ago, 12-Dec-02, to lugnet.cad.dev)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR