Subject:
|
Re: Error in Technic axle extender?
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Mon, 18 Mar 2002 04:07:28 GMT
|
Viewed:
|
1683 times
|
| |
|
|
In lugnet.cad.dev, Larry Pieniazek writes:
> In lugnet.cad.dat.parts, Fredrik Glöckner writes:
> > "Gary Williams" <gwlego@gw.ro> writes:
> >
> > > Or is the DAT file actually correct for the previous design of the part?
> >
> >
> > Yes. This has been discussed before. The original version of the
> > part looks like the one in the library, while the new one is the way
> > you describe.
> >
> >
> > I have a few of the original axle extenders from 8857 Street Chopper.
>
> What was the resolution on this? Any hope of getting a version that matches
> the "new" one? Usually you can just fudge it by rotating 45 degrees anyway,
> but once in a while it matters.
That's the beauty of the Ldraw parts library (and open-source in general) -
when it matters enough, it'll get done 8?)
ROSCO
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Error in Technic axle extender?
|
| (...) What was the resolution on this? Any hope of getting a version that matches the "new" one? Usually you can just fudge it by rotating 45 degrees anyway, but once in a while it matters. (25 years ago, 18-Mar-02, to lugnet.cad.dev)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
