 | | Re: re-name "patterned" parts?... —Steve Bliss
| | | | (...) This would do what you want, unless there was another, similar part, whose name is the same as the master part, except the final dimension included a fractional part, such as "... 2 & 1/3". Not that this is something that commonly collides (...) (24 years ago, 18-Dec-00, to lugnet.cad.dev)
| | | | | | | | | | Re: re-name "patterned" parts?... —Franklin W. Cain
| | | | | (...) Good point. I've only dealt with one part, so far, that this became an issue with: the (Minifig) Witch's Cauldron. But that one measured at "1/2" (inn between the plates for "1/3" and "2/3"), so I just used decimals (i.e., ".5"). If it had (...) (24 years ago, 21-Dec-00, to lugnet.cad.dev)
| | | | | | |
