 | | Re: part: boat mast base 4 x 4
|
|
i have just posted a fixed version of this piece to lugnet.cad.dat. let mw know if it is now fixed. the notches are still missing because i do not know how to adjuct the cylinders etc after i have inlined them. (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: parts i plan to do
|
|
(...) complex (...) which parts need type 5 lines? i have done the boat mast base. get it from lugnet.cad.dat i am working on the notches at the top. (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: parts i plan to do
|
|
(...) Good advice, Chris. I would like to also point out that many of the parts in that list have complex shapes that would require type 5 optional lines to have them look good. So Jonathan, you really need to have a good understanding of type 5 (...) (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: part: panel 1 x 2 x 1 with black grille pattern
|
|
(...) Your method also makes the pattern show up in wire-frame mode. Ideally, all the current parts should be changed to use the same method! Anyone want to take the challenge? --Bram Bram Lambrecht / o o \ BramL@juno.com (...) (26 years ago, 28-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: part: panel 1 x 2 x 1 with black grille pattern
|
|
i accually pulled the pattern straight of the 1 x 2 brick with black grille pattern because the patterened surfaces are the same size (26 years ago, 27-Feb-99, to lugnet.cad.dev)
|
