Subject:
|
Pneumatic air tank
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Fri, 28 May 1999 11:42:20 GMT
|
Viewed:
|
564 times
|
| |
|
|
I'm thinking about modeling the pneumatic air tank. But there is one
problem: I do not know what the tank looks like on the inside. With
this in mind, does it make sense to model only the _outside_ of the
tank?
Fredrik
|
|
Message has 2 Replies:
 | | Re: Pneumatic air tank
|
| at last! someone is modeling the air tank... do you think you could do the tee piece first? i need it for something i am working on. (25 years ago, 29-May-99, to lugnet.cad.dev)
| | | Re: Pneumatic air tank
|
| (...) I think you should cut one in half. Just kidding! The outside is all you can reasonably be expected to see, so that is all that is required. I would suggest that you might want to give the walls a little thickness, and make the interior (...) (25 years ago, 29-May-99, to lugnet.cad.dev)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
