 | | Re: Where should I center this one? —Terry Keller
| | | | (...) Exsqueeze me? Look again, Sproat. Some of the hinge pieces *are* centered on the hinge section: 3830 3831 2429 2430 3149 314 3324 -- Terry K -- (25 years ago, 25-May-99, to lugnet.cad.dev)
| | | | | | | | | | Re: Where should I center this one? —Bram Lambrecht
| | | | | | (...) Yeah, but only when the rotation point is in a normal position. I agree with Sproat, because the hinges will still be easy to position if left unturned. Also, whenever they are turned, it will most likely be in a sub model, so the insertion (...) (25 years ago, 25-May-99, to lugnet.cad.dev)
| | | | | | | | | | | | Re: Where should I center this one? —Jeremy H. Sproat
| | | | | (...) Whoops, you're right. But, in the case of the 1x2 plates and bricks, the centerpoint is on level with the top of a plane, and on the rectangular lattice formed by the studs. As for the 2x5 and 2x9 hinge plates, these are a real exception. (...) (25 years ago, 25-May-99, to lugnet.cad.dev)
| | | | | | |
