Subject:
|
Re: Space Craters Baseplate?
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Fri, 14 May 1999 10:28:05 GMT
|
Viewed:
|
1633 times
|
| |
|
|
Terry K wrote:
>
> On Fri, 14 May 1999 04:26:05 GMT, jamien@interworx.com.au (Jamie Obrien) wrote:
>
> > Hi, im new to ldraw but can't seem to find the baseplate that was out
> > in the 80's that had the craters and ridge on it. Is it in ldraw?
> > Sorry if it's a stupid question just starting out!
> >
> > Also, is there any site that has .dats of space sets?
>
> No, the cratered baseplate has not been done. That one may take a while, as it
> would be pretty difficult to model.
I once started to make it, but, as Terry says, it _is_ pretty difficult
to model.
I have the plate with the proper studs on it and the complete outline of
the "hill".
Wasn't there someone that could convert 3D Studio Max to DAT. I think it
would be fairly easy to make the hill and craters with Max and convert
it and place it on the baseplate...
--
Greetingz...
Sjaacko
|
|
Message has 2 Replies:
 | | Re: Space Craters Baseplate?
|
| (...) Good idea. That would probably simplify it a great deal. The problem is that Onyx (who wrote the Max2Dat) may not have that baseplate to model from. -- Terry K -- (27 years ago, 14-May-99, to lugnet.cad.dev)
|
Message is in Reply To:
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
