To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.devOpen lugnet.cad.dev in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / 1602 (-5)
  Re: Voting Page
 
(...) i aggreee. i was hpoing to see the slope brick 20 4 x 2, plate 3 x 3 corner round, minifig tool pickaxe, wing 6 x 12 and if it is finished the tie fighter bracket piece. (25 years ago, 9-May-99, to lugnet.cad.dev)
 
  Re: Voting Page
 
Where are all the Star Wars parts John VanZ had done. I thought they were supposed to be in the next vote?? :( I am glad to see that torsos and heads have been worked on. Ryan "Build or build not. There is no try." - Lego Master Yoda ***...*** REPLY (...) (25 years ago, 10-May-99, to lugnet.cad.dev)
 
  Re: Discussion-Large Technic Shock 2909c01.dat
 
(...) I have a fourth idea. It's a bit difficult to explain, but I'll try to make it clear: There would be a total of 3 pieces to make up the shock: A) Shock lower w/ half of spring B) Shock upper C) Spring upper half Since the spiral is fairly (...) (25 years ago, 9-May-99, to lugnet.cad.dev)
 
  Re: Voting Page
 
(...) parts like this normally lie flat in the X-Z-plane in LDraw? It makes sense to compare this part with the "Liftarm" parts in LDraw, and they all span the X-Z-plane. Fredrik (25 years ago, 9-May-99, to lugnet.cad.dev)
 
  Re: Voting Page
 
2 name suggestions... 1.minifog torso woth train chevron pattern to minifig torso with train worker pattern. 2. minifig ovoid shield to minifig shoild ovoid (for when we eventually move the castle shield ot the minifig catogory. also about the (...) (25 years ago, 9-May-99, to lugnet.cad.dev)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR