CAD Development : 1125

CAD / Development / 1125

1124 | 1126

Subject:	Re: part: brick 1 x 2 with computer screen and buttons pattern
Newsgroups:	lugnet.cad.dev
Date:	Sat, 10 Apr 1999 23:25:33 GMT
Viewed:	2251 times

> But I think you would benefit from having either a scan of the face of the > element or a copy of the actual element in hand. do you have one you can scan? > The three buttons along > the right, you have as being square, but they're actually supposed to be > circular. The positioning is also a bit off: you have the three buttons > taking up the entire vertical face of the brick, but on the real element, > there is room for four buttons, with only the top three appearing. That is, > it's as if the real element had four buttons, the bottom one being white > (i.e. invisible). thanks for the tip. i think i will post more of my ready for vote parts to get feedback as to which ones are realy ready. > As far as the decorations on the monitor go, I think parts authors try to get > the image as accurate as possible. It's going to be difficult to represent > the Danish[1] text on the screen that small, but it should be possible to > represent the general flow more accurately, including the visage in the lower > right corner. at that scale the square i have used for the part is the best i can get and not have the part look crap as smaller zoom levels.

Message has 2 Replies:

		Re: part: brick 1 x 2 with computer screen and buttons pattern
(...) Yes, I have several. And I have a scanner. But I won't scan them for you until you have either shown us that you can do a good job on at least one other part first, or, alternatively, if you agree to focus on this part until you get it right, (...) (28 years ago, 11-Apr-99, to lugnet.cad.dev)

		Re: part: brick 1 x 2 with computer screen and buttons pattern [DAT]
(...) Try something like: 1 1 0 0 0 2 0 0 0 0 2 0 0 0 4-4disc.DAT 1 16 0 0 0 2 0 0 0 0 2 0 0 0 4-4ndis.DAT For the buttons/lights. That looked pretty good when I used it to build a panel of the three buttons. Not great at Zoom=1, but more accurate (...) (28 years ago, 12-Apr-99, to lugnet.cad.dev)

Message is in Reply To:

		Re: part: brick 1 x 2 with computer screen and buttons pattern
(...) I don't remember the other one, but here is some feedback on this one: First of all, it looks very nice and it looks like you have got the geometry of the 1x2 brick correct. But I think you would benefit from having either a scan of the face (...) (28 years ago, 10-Apr-99, to lugnet.cad.dev)

6 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact