 | | Re: 3D matrix math question
|
|
(...) Actually, the projected points are all that I am checking, and that's how it's supposed to work. (...) No. The way that conditional lines work is that if the two control points lie on the same side of the conditional line on the screen (in (...) (16 years ago, 14-Dec-08, to lugnet.cad.dev, FTX)
|
| |
| | Re: 3D matrix math question
|
|
(...) If I understand correctly you shouldn't be checking on the projection, only on the full 3D transformed points. That means you should check after stage 2.5. You'll need the Z value to work out which side things lie on. Tim (16 years ago, 14-Dec-08, to lugnet.cad.dev, FTX)
|
| |
| | 3D matrix math question
|
|
(...) I think I need help. I thought I was using gluProject for the conditional calculations, but discovered that I'm not. I multiple the projection matrix by the model-view matrix to get my transformation matrix, then run the points through that to (...) (16 years ago, 14-Dec-08, to lugnet.cad.dev, FTX)
|
| |
| | Re: LETGUI new version 0.1.0.18
|
|
(...) Thanks! For the record: - Ytruder 1.2 is no longer limited to Y direction and can extrude along x, y or z directions - Intersector 1.3 has a new scaling option that improves result for small parts. Philo (16 years ago, 12-Dec-08, to lugnet.cad.dev)
|
| |
| | LETGUI new version 0.1.0.18
|
|
A new version of LETGUI ((URL) is now available. Support for new commandline options for Ytruder1.2 and Intersector1.3 are added. Have fun! cu mikeheide (16 years ago, 12-Dec-08, to lugnet.cad.dev)
|
| |
| | Re: Inliner v1.1.0.1
|
|
(...) There where still under some circumstances errors in the resulting file. Please use this update version 1.1.0.2 at (URL) (16 years ago, 10-Nov-08, to lugnet.cad.dev)
|
| |
| | LETGUI new version 0.1.0.17
|
|
A new version of LETGUI ((URL) is now available. The new option 'N' for Inliner ((URL) is now supported. Support for the new amazing tool pathtruder v1.0 ((URL) is added. Have fun! cu mikeheide (16 years ago, 27-Oct-08, to lugnet.cad.dev)
|
| |
| | Inliner v1.1.0.1 [DAT]
|
|
A new version of Inliner is available at (URL) is a bugfix, that fixes the wrong winding if you use the inlinedeep option and do not inline to the lowest level. So this version can now easily change a CW version of a file to a CCW version. You have (...) (16 years ago, 25-Oct-08, to lugnet.cad.dev)
|
| |
| | LETGUI new version 0.1.0.16
|
|
A new version of LETGUI ((URL) is now available. The new option for Inliner ((URL) is now supported. Have fun! cu mikeheide (16 years ago, 18-Oct-08, to lugnet.cad.dev)
|
| |
| | Inliner v1.1
|
|
A new version of Inliner is available at (URL) you can choose the deepth of inlining level. cu mikeheide (16 years ago, 12-Oct-08, to lugnet.cad.dev)
|
