 | | Re: LSynth electric cable cross section oriention problem
|
|
(...) Leo, In case you didn't get this far, I solved the above problem and can now control twist all through a cable segment from start point to end point. I calculate the up vector for the start of segment, and the up vector for the end of segment. (...) (18 years ago, 26-Nov-06, to lugnet.cad.dev)
|
| |
| | LDAO problem
|
|
i guess this would be the correct spot for the message. i have a install problem with LDAO. i install it, and when i stat it i get error 76 , path not found. (18 years ago, 26-Nov-06, to lugnet.cad.dev)
|
| |
| | Re: LSynth electric cable cross section oriention problem
|
|
I've got up/side/front vector stuff working now, so that I can control the orientation of cross sections of electrical cables at the start of a segment defined by two constraints. My issue now is that I don't know how to force the twist so that the (...) (18 years ago, 24-Nov-06, to lugnet.cad.dev)
|
| |
| | Re: bend thingie creator.
|
|
(...) Let me check my archive of LDraw related programs and if I have it I'll email it to you. -Orion (18 years ago, 24-Nov-06, to lugnet.cad.dev)
|
| |
| | LSynth electric cable cross section oriention problem
|
|
Hi, I've got a reworked version of LSynth with a major problem... I cannot figure out how to control the twist of the cross section. I use bezier curve to created the nicely curved set of points, and compress it by tossing out points until the angle (...) (18 years ago, 24-Nov-06, to lugnet.cad.dev)
|
