|
| | Re: Issue with some of the holds on the Parts Tracker
|
| Hello Orion, I think you may refer to some hold votes i did today. (...) I would never hold a part because of some bad vertex sequences only. But identical lines are a reason for doing this. Refer to the parts tracker documentation for L3P-error (...) (22 years ago, 11-Jun-02, to lugnet.cad.dev)
| | | | Issue with some of the holds on the Parts Tracker
|
| I am at issue with some the hold votes that have given to parts on the PT. As the certify statement says, a part is certified if it is good for general release. In other words, we're not looking for absolute perfection, we are looking for a part (...) (22 years ago, 11-Jun-02, to lugnet.cad.dev)
| | | | Re: Minifig Cloth Cape
|
| (...) Not at this time - the Compactor preserves all decimals (except trailing zeroes, which it removes). The intent of the Compactor is to remove all extraneous material, without altering the actual data. If you want to trim all your lines to 3 (...) (22 years ago, 11-Jun-02, to lugnet.cad.dev)
| | | | Re: mouse model manipulation
|
| (...) [snip] (...) Ah ha, that comment comes from the ldlite parser. Try the l3 parser by renaming the executable to l3glite or by passing -l3 on the command line. It's much faster for interactive stuff. However, LEDIT mode should already be using (...) (22 years ago, 11-Jun-02, to lugnet.cad.dev.mac)
| | | | Re: mouse model manipulation
|
| (...) Just clicking on the model in preparation for mouse rotation (LDGLite mode) gives pdn(314, 219), -> (-6.00, 21.00, -4000.00) platform_step(-1, 2, 0) platform_step(-1, 2, 0) platform_step(-1, 2, 0) platform_step(-1, 2, 0) platform_step(0, 1, 1) (...) (22 years ago, 11-Jun-02, to lugnet.cad.dev.mac)
| |