 | | part(s) posted... (set #4817)
|
|
I went with pattern number "4f", since "4b" has been taken by some other torso. Minifig Hips & Legs with Leather Armor Pattern (Complete) (URL) Hips with Leather Belt (Red Studs) Pattern (URL) Leg Right with Leather Straps (Red Studs) Pattern (URL) (...) (24 years ago, 10-Apr-02, to lugnet.cad.dev)
|
| |
| | Re: Parts as volumes (instead of surfaces)
|
|
(...) That was only bounding boxes (minus the studs). The piece in question was matched against all other pieces, any pieces in a line above or below were put into a list. In case one of them intersected the piece in question, a new place would be (...) (24 years ago, 10-Apr-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Parts as volumes (instead of surfaces)
|
|
(...) So stud4 would be decomposed into 16 trapezoidal prisms? That sounds like a fair amount of mark up. (...) Nod, true. But I'd rather decompose a 1x1 brick into 6 volumes (4 walls, 1 top and the stud) than 46 (one volume for each surface (...) (24 years ago, 10-Apr-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: matching pattern numbers???
|
|
(...) When reasonable, yes, we should. If I make the Johnny Thunder face today, but don't make his torso for a couple of years, I wouldn't expect that the same pattern number will necessarily be available later. There are too many patterns for that. (...) (24 years ago, 10-Apr-02, to lugnet.cad.dev)
|
| |
| | Re: matching pattern numbers???
|
|
(...) This sounds like a sensible suggestion. The change should of course be made, so there are only minimal (if any) changes to the names of already published parts. Jacob (24 years ago, 10-Apr-02, to lugnet.cad.dev)
|
