| | Re: A discovery? and part 3475
|
|
(...) I have made a function in LDraw-mode which does this. In your example, you would put the cursor on the first type-2 line in the first edge, set the mark (C-SPC) move down to the first type-2 line in the second curve and hit C-c C-f. Voila. The (...) (25 years ago, 2-Apr-00, to lugnet.cad.dat.parts, lugnet.cad.dev)
|
|
| | Type-5 conditional edge line
|
|
I have a question about the type-5 conditional line. Assume I have four points in 3d space like this: (If you're reading LUGNET via the web interface, you must push "view raw message" to see my ASCII art.) 1---2 | | | | | | 4---3 Except that the (...) (25 years ago, 1-Apr-00, to lugnet.cad.dev)
|
|
| | PIPE function... [DAT]
|
|
I've made a new function for LDS called PIPE. It's an extension of the LINE function. Remember:? LINE POINT x y z POINT x y z ... POINT x y z LINE END Now, PIPE works the same way but with that difference it's in 3D: PIPE [n_sectors total_sectors] (...) (25 years ago, 1-Apr-00, to lugnet.cad.dev)
|
|
| | Re: What is BFC meta command ?
|
|
(...) What if I am creating a new part? Regards John (25 years ago, 1-Apr-00, to lugnet.cad.dev)
|
|
| | Re: BFC: LITS 2
|
|
Steve: (...) No. - Or rather: That depends on how good looking a rendering you want. Thinking a bit more about it, I think we can get just as good result _with_ clipping of transparent surfaces as without. Yes, transparent surfaces can be clipped! (...) (25 years ago, 1-Apr-00, to lugnet.cad.dev)
|