|
|
 | | Re: stl2dat conversion tool beta2
|
| (...) This should be one of your top priorities, since unwanted data only slows down the rendering programs. (...) Iep, but the valid values for the angle differ. (...) See my previous reply about merges ! (...) I don't think so ! Where have you (...) (25 years ago, 14-Feb-00, to lugnet.cad.dev)
| | | | | Re: stl2dat conversion tool beta3
|
| (...) haven't eaten all weekend, cheesh, Boy was I ungry last Night. (...) OK. (...) Be carefull, with these merges, because every time you merge two polys, by a facet, you remove 1 or 2 points (tris or quads). And you can only due this if they are (...) (25 years ago, 14-Feb-00, to lugnet.cad.dev)
| | | | | Re: stl2dat conversion tool beta2
|
| (...) Until here the ascii ART is correct, but from here on forward it's NOT, because the ascii art is representing a front view, and nothing tells you that poly [1 3 4 2] is coplanar with tri [3 6 4] In fact if you read the previous mails carefully (...) (25 years ago, 14-Feb-00, to lugnet.cad.dev)
| | | | | Re: stl2dat conversion tool beta2
|
| (...) The normal is explicitely given in STL files. (...) Yes. I have planed to optimize this point. I think it is the same case for internal cylinders. The angle must be convex and not concav. However, it is not done yet. (...) I use case 1: _ _ (...) (25 years ago, 14-Feb-00, to lugnet.cad.dev)
| | | | | Re: New LDraw version ?
|
| (...) Read lugnet.cad.*. Lotsa messages in the last few days. But you probably know that by now. (...) Umm, Tim, you *might* want to re-iterate just what information is needed for a download page on ldraw.org. Specifically, the author needs to (...) (25 years ago, 14-Feb-00, to lugnet.cad.dev)
|
|
