 | | Re: Part number needed & New primitive submission
|
|
(...) center and (...) can (...) The way this primitive is designed saves time for the part author (not a whole lot, but some). Once you have the dimensions you want you just plug those in directly without having to divide them by two. When you use (...) (25 years ago, 28-Jul-99, to lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives, lugnet.cad.dev)
|
| |
| | Re: what are the rules about hoses etc?
|
|
(...) Hoses go in the model. End of discussion (unless a serious user comes up with a really good and logical reason otherwise). (...) When it becomes possible, they are required too. (...) Yes and no. Some parts, depending on where they are in the (...) (25 years ago, 28-Jul-99, to lugnet.cad.dev.org.ldraw)
|
| |
| | Mirroring in LDraw (was: Re: what are the rules about hoses etc?)
|
|
(...) It's not that much more complicated, as long as you want to mirror across the *model's* orientation, not the *part's* orientation. If you've got a part command: 1 15 x y z a b c d e f g h i part.dat And you want to mirror on X (switch right (...) (25 years ago, 28-Jul-99, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Part number needed & New primitive submission
|
|
(...) I think the box should conform to the same geometry as the other box* primitives -- it should range from -1 to +1, not -.5 to +.5. Steve (25 years ago, 28-Jul-99, to lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives, lugnet.cad.dev)
|
| |
| | Re: Part number needed & New primitive submission
|
|
A few things I noticed/suggestions: 1. The way you use box4nl, you are drawing a bunch of quads which will never be seen. Drop the end-quads from box4nl. 2. On the outside frame, butted-construction is not the best way to put graphics primitives (...) (25 years ago, 28-Jul-99, to lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives, lugnet.cad.dev)
|
