|
| | Re: what are the rules about hoses etc?
|
| On Sun, 25 Jul 1999 23:52:41 GMT "Ryan Dennett" <dennett@agate.net> writes: ^^^^ You finally fixed the email address! ;) (...) point (...) If it goes from the right point to the right point, it should end up looking pretty much like the real hose (...) (25 years ago, 26-Jul-99, to lugnet.cad.dev.org.ldraw)
| | | | Re: what are the rules about hoses etc?
|
| (...) Of course you have to do the hoses. I don't think that in making the hoses they have to be as shown, but as long as they go from correct point A to correct point B, and don't interfere with any other pieces(going through them) it should be (...) (25 years ago, 25-Jul-99, to lugnet.cad.dev.org.ldraw)
| | | | Re: DAT2DXF?
|
| (...) Check out (URL) good resource for this type of thing is right here at (URL) (25 years ago, 25-Jul-99, to lugnet.cad.dev)
| | | | DAT2DXF?
|
| Where can I find this program? Thanks, Adam (25 years ago, 25-Jul-99, to lugnet.cad.dev)
| | | | Re: Part number needed & New primitive submission
|
| Never seen the part in question, but it looks ok. The new primitive seems ok, too. Very unusual that it starts from the center and goes from -0.5 to 0.5 in all directions. I don't know if I like it, but I can surely live with it. I like the name. nl (...) (25 years ago, 25-Jul-99, to lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives, lugnet.cad.dev)
| |