|
| | Re: Voting Comments
|
| (...) That's a really great idea! It's obvious you're pretty experienced with LDraw. I'll do the changes when I get home. Fredrik (25 years ago, 19-May-99, to lugnet.cad.dev)
| | | | Re: Voting Comments
|
| (...) You are indeed correct, yes. Thanks a lot. I took the time to "brush up" the surface around the axle holes as well. I believe the current solution is a better one; I no longer use partially overlapping 2-4rings to cover the surface. The part (...) (25 years ago, 19-May-99, to lugnet.cad.dev)
| | | | Re: Voting Page [DAT]
|
| I've noticed an error in part #30250, that was named "Brick 2 x 4 x 3 Notched with Side 5 x 4 Plate" during the vote. Four box5.dat primitives have been used to form "friction rims" at the under/inside of the part, but they are not properly rotated. (...) (25 years ago, 19-May-99, to lugnet.cad.dev)
| | | | Re: Part Name Question
|
| jonathan wilson wrote in message ... (...) No, no more "space" required I think. A generic category like "bar" would be nicer. But I admit that there is no simple definition for "bar" category for this part like "space gun 1x8" Selçuk (25 years ago, 19-May-99, to lugnet.cad.dev)
| | | | Re: new part description changes?
|
| Terry K wrote in message <37422782.12164362@l...et.com>... (...) Any (...) Looks nice to me, too. (...) Corners", (...) I strongly agree. By the way, I don't think the part that Steve pointed out should be considered as "w/o corners" variety. It is (...) (25 years ago, 19-May-99, to lugnet.cad.dev)
| |