 | | Re: Making parts 2999 and 2998 work together
|
|
(...) I say reposition 2999. I think that the few, if any, models that use this part could be updated with relative ease and the frustration saved by going this route would offset any inconveinence. -Orion (22 years ago, 3-Feb-03, to lugnet.cad.dev)
|
| |
| | Making parts 2999 and 2998 work together
|
|
I posted a 'hold' review on the wheel from the 8080 Super Car (part 2998). You can read it at: (URL). The part file itself is good. Unfortunately, 2998 only fits with part 2999 (see 2999 at (URL). 2999 was released back in 1998. Right now, the two (...) (22 years ago, 2-Feb-03, to lugnet.cad.dev)
|
| |
| | Attention, Mark Kennedy!
|
|
Hey Mark! The email address we've got for you on the Parts Tracker, kennedy@proaxis.com, seems to not be working. Messages sent to that address have bounced with 550 errors. Do you have a different address, or is this a temporary problem? Steve (22 years ago, 2-Feb-03, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Need for rect primitive with two or one edge?
|
|
(...) What was it missing? We did have a problem running out of disk space recently, that could have caused the trouble. (...) I've rebuilt the zip file. I should probably set that up to run as a daily job. Steve (22 years ago, 1-Feb-03, to lugnet.cad.dat.parts.primitives, lugnet.cad.dev)
|
| |
| | Updated Axle and Connect POV primitives
|
|
I updated the axle and connect primitve POV file. I also added POV code to the axlehole and connect primitves so that L3P add my code automatically. I put these in a zip file that just needs to be put into the /P directory. let me know if these are (...) (22 years ago, 1-Feb-03, to lugnet.cad.ray, lugnet.cad.dev)
|
