To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.dat.parts.primitivesOpen lugnet.cad.dat.parts.primitives in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / LDraw Files / Parts / Primitives / 358
  Re: Stud5 and type 5 lines at edge of cylinders.
 
(...) I think ideally this would be used on all segmented primitives that are circular and not flat (obviously it doesn't apply to primitives like disks and rings). So think that the same logic would apply to cones. Incidentally, I think the 1/8 (...) (21 years ago, 3-Oct-03, to lugnet.cad.dat.parts.primitives, FTX)
 
  Re: Stud5 and type 5 lines at edge of cylinders.
 
(...) Ok, so... that could also mean torii as well... again, the primitive generator and past spreadsheets do this the "old" way. I will have to look into that as well. (...) I believe you are correct. (...) I agree. Should I make this an option on (...) (21 years ago, 8-Oct-03, to lugnet.cad.dat.parts.primitives, FTX)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR