 | | Re: Stud5 and type 5 lines at edge of cylinders.
|
| (...) That's what I was afraid of... That is not how I handled it in the program. So, now this should apply for any segment files, right? 1-16,1-8,3-16,1-4,7-48, etc? If so, I will have to rethink how to calculate those points. now... this brings us (...) (21 years ago, 2-Oct-03, to lugnet.cad.dat.parts.primitives, FTX)
| | | | | Re: Stud5 and type 5 lines at edge of cylinders.
|
| (...) I think ideally this would be used on all segmented primitives that are circular and not flat (obviously it doesn't apply to primitives like disks and rings). So think that the same logic would apply to cones. Incidentally, I think the 1/8 (...) (21 years ago, 3-Oct-03, to lugnet.cad.dat.parts.primitives, FTX)
| | | | | Re: Stud5 and type 5 lines at edge of cylinders.
|
| (...) Ok, so... that could also mean torii as well... again, the primitive generator and past spreadsheets do this the "old" way. I will have to look into that as well. (...) I believe you are correct. (...) I agree. Should I make this an option on (...) (21 years ago, 8-Oct-03, to lugnet.cad.dat.parts.primitives, FTX)
| |
