 | | Re: Why aren't the technic gear teeth primitives? —Steve Bliss
|
| | | (...) Are the teeth the same between different parts? If they are different, it doesn't make much sense to have primitives for each one. Even if the teeth are different, it would be possible to make subfiles for the teeth. This could make sense for (...) (23 years ago, 28-Mar-02, to lugnet.cad.dat.parts.primitives)
|
| | | |
| | | | | Re: Why aren't the technic gear teeth primitives? —Mark Kennedy
|
| | | | (...) editing (...) The teeth on the small 8 tooth gear are slightly different from the larger ones(Though in the file they are pretty much drawn as trapezoidal boxes). But on the two beveled gears they apear practicly identical as far as I can (...) (23 years ago, 29-Mar-02, to lugnet.cad.dat.parts.primitives)
|
| | | | |
| | | | | | Re: Why aren't the technic gear teeth primitives? —Thomas Avery
|
| | | | (...) If they were designed properly, the tooth profiles will be different between the 8t, 24t, etc. gears. The tooth profile of a gear follows an involute curve, which means the profile is the involute of a base circle slightly smaller than the (...) (23 years ago, 29-Mar-02, to lugnet.cad.dat.parts.primitives)
|
| | | | |
