 | | Re: new part - 71014 Castle Greatsword
|
|
Franklin W. Cain <fwcain@yahoo.com> wrote in message news:Frvx6z.Bv@lugnet.com... (...) But I think the edge lines ended up inside the torii, instead of between them. (...) I can appreciate the shudder, because putting those edgelines around the (...) (25 years ago, 23-Mar-00, to lugnet.cad.dat.parts)
|
| |
| | Re: new part - 71014 Castle Greatsword
|
|
(...) Did I hear my cue? The rotate.xls file is at my Geocities site: (URL) Steve (25 years ago, 24-Mar-00, to lugnet.cad.dat.parts)
|
| |
| | Re: new part - 71014 Castle Greatsword
|
|
(...) Hey, Steve, When I clicked on that link, I got the "Page Unavailable" error message. :-( Thanks, Franklin (25 years ago, 24-Mar-00, to lugnet.cad.dat.parts)
|
| |
| | Re: new part - 71014 Castle Greatsword
|
|
(...) OK, I copied the relevant lines into a separate DAT file, and -- well, it wasn't so much that the edge lines were inside the torii (they were) as that I put the "cones" (for making the torii) in the wrong places. :-P~~~ I've fixed this here. (...) (25 years ago, 24-Mar-00, to lugnet.cad.dat.parts)
|
| |
| | Re: new part - 71014 Castle Greatsword
|
|
(...) It's there. Try again. Or go to my main page: (URL) and follow the link from there. Steve (25 years ago, 24-Mar-00, to lugnet.cad.dat.parts)
|
| |
| | Re: new part - 71014 Castle Greatsword
|
|
Franklin W. Cain <fwcain@yahoo.com> wrote in message news:FrxKs8.IGz@lugnet.com... (...) Franklin, Thanks for your committment to creating quality parts! I predict you will become a true part artist! -John Van (25 years ago, 27-Mar-00, to lugnet.cad.dat.parts)
|
