| | 32191.dat and request photo of Technic Panel #3 and #4 (32188) Marc Klein
|
| | I have started model Technic Panel #1 and #2 (part 32190 and 32191). You can have a look here: (URL) would also like to model Technic Panel #3 and #4 (part 32188 and 32189), but I dont have the parts. Could someone send me a good picture of these (...) (25 years ago, 18-Feb-00, to lugnet.cad.dat.parts)
|
| | |
| | | | Re: 32191.dat and request photo of Technic Panel #3 and #4 (32188) Tore Eriksson
|
| | | | Sorry Marc, but you made links to the pic's on your local drive. /Tore (25 years ago, 18-Feb-00, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: 32191.dat and request photo of Technic Panel #3 and #4 (32188) Marc Klein
|
| | | | | (...) Sorry, its ok now. (URL) Klein (25 years ago, 19-Feb-00, to lugnet.cad.dat.parts)
|
| | | | | |
| | | | re: Request photo of Technic Panel #3 and #4 (32188) Steve Bliss
|
| | | | (...) Marc, You haven't submitted any parts for L-CAD parts updates[1], and if you don't plan to, the following warning doesn't matter. A while ago, an issue came up where someone was modeling parts that he did not posess. The general feeling was (...) (25 years ago, 18-Feb-00, to lugnet.cad.dat.parts)
|
| | | | |
| | | | Re: 32191.dat and request photo of Technic Panel #3 and #4 (32188) Steve Bliss
|
| | | | (...) Why are there angled lines in the bottom view (32191d.gif)? Steve (25 years ago, 18-Feb-00, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: 32191.dat and request photo of Technic Panel #3 and #4 (32188) Marc Klein
|
| | | | (...) It's because i use my stl2dat converter and it is not completely debugged yet. The part has been modelised with solidworks. BTW is it a correct way in dat part to use a 2-4cyli.dat cylindric primitives when the cylinder does not have exactly (...) (25 years ago, 19-Feb-00, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: 32191.dat and request photo of Technic Panel #3 and #4 (32188) Steve Bliss
|
| | | | (...) This not the best way to proceed. It is better to use 3-8cyli.dat instead, and then hard-code the last polygon (or two), based on the polygons from 1-4cyli.dat. But the approach you describe has been used on some parts. Steve (25 years ago, 21-Feb-00, to lugnet.cad.dat.parts)
|
| | | | |