Subject:
|
Re: [PART] 2717 Technic Seat (at last!)
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Tue, 1 Feb 2000 22:19:44 GMT
|
Viewed:
|
3447 times
|
| |
|
|
John VanZwieten wrote:
> Nice job!
Thanks! :o)
> I think it's missing a couple edgelines. Let's see if I can
> describe the area: looking at the part from the back in oblique view, the
> sloping back of the seat meets the vertical back of the part, but the sides
> of the seat back continue to slope down almost to the bottom of the part. At
> the very lowest portion of this sloping surface, you used a 1-4disc. I think
> it needs an edgeline where the 1-4disc meets the body of the part, and
> perhaps also where it meets the sloping surface, since the 1-4 disc seems to
> be vertical. If you look at the part in wireframe mode (oblique view),
> you'll notice an edge which doesn't connect to anything--which is the only
> reason I noticed this.
Yes, the 1-4disc is vertical. If I remeber correctly, the Z/Y propotions should be 1/4.
I'll have a look at it, as well as the missing lines you say that you've found..
>
>
> Also, I don't get a conditional line showing up at the front of the armrest
> when the part is viewed from the back obliquely.
Yes, I'm aware of that. I thought of them some time after the part was submitted.
>
>
> -John Van
>
> Tore Eriksson <tore.eriksson@mbox325.swipnet.se> wrote in message
> news:3890C876.5F54662E@mbox325.swipnet.se...
> > 0 Technic Seat
> > 0 Name: 2717.dat
> > 0 Author: Tore Eriksson
> > 0 Un-Official Part
> >
> >
|
|
Message is in Reply To:
 | | Re: [PART] 2717 Technic Seat (at last!)
|
| Nice job! I think it's missing a couple edgelines. Let's see if I can describe the area: looking at the part from the back in oblique view, the sloping back of the seat meets the vertical back of the part, but the sides of the seat back continue to (...) (27 years ago, 1-Feb-00, to lugnet.cad.dat.parts)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
