Subject:
|
Re: 57587.dat origin
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 8 May 2009 21:32:36 GMT
|
Viewed:
|
11668 times
|
| |
|
|
In lugnet.cad.dat.parts, Santeri Piippo wrote:
| |
Hello all, I have recently been working on 57587.dat, “Technic Cylinder 6 x 6 x 4 with Dome Top” (though I have it here
titled as “Technic Dome 7 x 7 x 5” because IMHO it’s more like a dome than a
cylinder).
I’ve noticed the part origin is a problem once more, and thus I’m asking if
people would have ideas on where the origin is going to be instead of
submitting the thing to the tracker; if I ask now I guess I get responses
earlier (and the problem is quicker sorted out).
So the question is: where does the origin go in 57587.dat? I have uploaded
the part in MPD form as it is at the time of writing this post
here.
The X- and Y-axes are sure obvious, to the center of the part. The emphasis
of this question is the origin on the Z-axis.
|
I would rotate that part, so it is easier to identify this part as a dome.
Then I think the top should be at Y=0.
I have already send a manipulated version of your mpd file to your address.
cu
mikeheide
|
|
Message has 1 Reply:
 | | Re: 57587.dat origin
|
| (...) Interesting... I'm agreeing with you, as it seems other dome parts have their top pointing upwards so I shall do it this way. Thank you. (16 years ago, 9-May-09, to lugnet.cad.dat.parts, FTX)
|
Message is in Reply To:
| | 57587.dat origin
|
| Hello all, I have recently been working on (URL).dat, "Technic Cylinder 6 x 6 x 4 with Dome Top" (though I have it here titled as "Technic Dome 7 x 7 x 5" because IMHO it's more like a dome than a cylinder). I've noticed the part origin is a problem (...) (16 years ago, 8-May-09, to lugnet.cad.dat.parts, FTX)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
