 | | Re: x210c01 ChromeSilver Drill 4 x 4 x 7
|
|
(...) I do not understand correctly what you are saying. If you use a cone primitive you can stretch it in all direction. There is no need to use "about 40 cones". A maximum of 10 should do the same! You should use for this the program "cones and (...) (16 years ago, 12-Dec-08, to lugnet.cad.dat.parts)
|
| |
| | Re: x210c01 ChromeSilver Drill 4 x 4 x 7
|
|
(...) Welcome back! (...) I agree with Mikeheide, since the total curvature is low I think 6 cones would be more than enough! (...) Seems a good approach. As for the edge line between screw and cones, Isecalc will provide it instantly! (It would be (...) (16 years ago, 12-Dec-08, to lugnet.cad.dat.parts)
|
| |
| | Re: x210c01 ChromeSilver Drill 4 x 4 x 7
|
|
(...) When the curvature is the only concern, then yes, but I have to take the screwshape into consideration, the closer I am to the ideal curve, the easier it is to calculate the screwshape and avoid holes in the part. Furthermore when thinking (...) (16 years ago, 13-Dec-08, to lugnet.cad.dat.parts)
|
