Subject:
|
Re: Question about "stickers"
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Mon, 5 Sep 2005 22:02:21 GMT
|
Viewed:
|
3161 times
|
| |
|
|
In lugnet.cad.dat.parts, Mark Chittenden wrote:
> In lugnet.cad.dat.parts, Orion Pobursky wrote:
> > You make the sticker whatever size it actually is. If it's 40 LDU wide and
> > extend to the edges then that's what you make. A sticker is just like any other
> > part: it must be modelled as close to the real life part as possible (including
> > size).
> >
> > -Orion
>
> Well, specifically I'm working on modeling the stickers from set 0375 (Fort with
> Knights aka the Yellow Castle), in particular the shield and vest stickers. But
> since I do not own an actual copy of set 0375, I can't measure the actual
> stickers. I have jpg scan copies of one sticker sheet example, but I can't tell
> how big the stickers would be compared to the surface they are to stick to
> (since the scans are high resolution, they do not print out at "actual size").
> Can anyone out there provide actual measurements of the stickers from this set?
>
>
> p.s: I do have a couple shields with original stickers still attached, but there
> are differences in the sticker's sizes as well as in the colors (apparently
> there have been a few printing differences in the stickers for this set).
hi mark,
I've never got reply when I sent you the scan of my stickers (suppose the mail
has been eaten up by some spam filter) and therefore I'll post the link her:
http://www.holly-wood.it/tmp/castle.jpg (234 KB)
I also measured the stickers (though they are not in the best shape :-( and I've
got an average width of 14.7 mm. using paul's LCad calculator you'll get 37.039
LDU. I suggest rounding the stickers to 37 LDU.
bye, w.
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Question about "stickers"
|
| (...) Well, specifically I'm working on modeling the stickers from set 0375 (Fort with Knights aka the Yellow Castle), in particular the shield and vest stickers. But since I do not own an actual copy of set 0375, I can't measure the actual (...) (19 years ago, 16-Aug-05, to lugnet.cad.dat.parts)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
