To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.dat.partsOpen lugnet.cad.dat.parts in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / LDraw Files / Parts / 5701
5700  |  5702
Subject: 
Re: Question about "stickers"
Newsgroups: 
lugnet.cad.dat.parts
Date: 
Tue, 16 Aug 2005 19:43:39 GMT
Viewed: 
3590 times
  
In lugnet.cad.dat.parts, Orion Pobursky wrote:
You make the sticker whatever size it actually is.  If it's 40 LDU wide and
extend to the edges then that's what you make.  A sticker is just like any other
part: it must be modelled as close to the real life part as possible (including
size).

-Orion

Well, specifically I'm working on modeling the stickers from set 0375 (Fort with
Knights aka the Yellow Castle), in particular the shield and vest stickers. But
since I do not own an actual copy of set 0375, I can't measure the actual
stickers. I have jpg scan copies of one sticker sheet example, but I can't tell
how big the stickers would be compared to the surface they are to stick to
(since the scans are high resolution, they do not print out at "actual size").
Can anyone out there provide actual measurements of the stickers from this set?


p.s: I do have a couple shields with original stickers still attached, but there
are differences in the sticker's sizes as well as in the colors (apparently
there have been a few printing differences in the stickers for this set).



Message has 1 Reply:
  Re: Question about "stickers"
 
(...) hi mark, I've never got reply when I sent you the scan of my stickers (suppose the mail has been eaten up by some spam filter) and therefore I'll post the link her: (URL) (234 KB) I also measured the stickers (though they are not in the best (...) (19 years ago, 5-Sep-05, to lugnet.cad.dat.parts)

Message is in Reply To:
  Re: Question about "stickers"
 
(...) You make the sticker whatever size it actually is. If it's 40 LDU wide and extend to the edges then that's what you make. A sticker is just like any other part: it must be modelled as close to the real life part as possible (including size). (...) (19 years ago, 13-Aug-05, to lugnet.cad.dat.parts)

8 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR