 | | Re: Onion Dome (part 44511) from Orient Expedition sets
|
|
In lugnet.cad.dat.parts, William Howard wrote: (snip) I wanted to close the loop on this.. William is right, and I was incorrect about the cross section. I agree that there is no recurve in the part, and thus no figure 8 cross sections when put back (...) (22 years ago, 31-May-04, to lugnet.cad.dat.parts)
|
| |
| | Plant Brick 1 x 1 Round with 3 Bamboo Leaves
|
|
Has anyone modelled this part: (URL) it does not seem hard, but I do not have the skills to make it. Just use the 1x1 brick round and model the leaves once and use them three times? :-) Jaco (22 years ago, 30-May-04, to lugnet.cad.dat.parts)
|
| |
| | Question about creating Cone 4 x 4 x 3 for LDraw
|
|
(...) I happened to get me a seccond hand trainset 725, including two of these cones. So I have started on creating this part for LDraw. By looking at the orientation of the stud and the inner details it seems that this part was creating 45 degrees (...) (22 years ago, 30-May-04, to lugnet.cad.dat.parts)
|
| |
| | Re: "Minifig Fire Helmet Breathing Hose"(x171)
|
|
(...) I am sorry to tell you that this part is currently not appear in MLCAD or LDRAW, you might try to use other parts to replace just as that avitor goggles (22 years ago, 30-May-04, to lugnet.cad.dat.parts)
|
| |
| | Re: 10129 Rebel Snowspeeder
|
|
(...) Orion, Are either of the wedge parts you mentioned available, either officially or unofficially? Thanks. -Joel (22 years ago, 29-May-04, to lugnet.cad.dat.models.sets, lugnet.cad.dat.parts)
|
