 | | Re: New part: Plate 6 x 6 x 2/3 Cross with Dome - 30303.dat
|
|
James J. <jejackso@memphis.edu> wrote in message news:FLnt1u.HHB@lugnet.com... (...) started (...) I actually have this one mostly completed. I was waiting for a new primitive to be added. -John Van (25 years ago, 23-Nov-99, to lugnet.cad.dat.parts)
|
| |
| | Re: New part: Plate 6 x 6 x 2/3 Cross with Dome - 30303.dat
|
|
(...) Did you reach any conclusions as to wether the 1x2 plate is connected at a 90° angle or not? I seem to remember this discussion earlier on, but cannot remember what the conclusion was. Fredrik (25 years ago, 23-Nov-99, to lugnet.cad.dat.parts)
|
| |
| | Re: New part: Plate 6 x 6 x 2/3 Cross with Dome - 30303.dat
|
|
(...) I got just one response from someone who measured the angle on his as being 86 or 87 degrees. -John Van (25 years ago, 23-Nov-99, to lugnet.cad.dat.parts)
|
| |
| | Re: New part: Plate 6 x 6 x 2/3 Cross with Dome - 30303.dat
|
|
(...) This is going to be a fairly difficult part to use, with that odd angle. I remember reading your original post about the non-perpendicularity of the 1x2 bracket plate. The first thing I did when I came home was to take out my own parts to (...) (25 years ago, 24-Nov-99, to lugnet.cad.dat.parts)
|
