| |
In lugnet.cad, Bernd Broich wrote:
> Marek Idec wrote:
> > <snip...>
> > I sent my result to the Parts Tracker, where you cas see
> > it: http://www.ldraw.org/cgi-bin/ptdetail.cgi?s=6055 My problem is
> > that I don't own any piece of this part, so I could rely only on
> > pictures from building instruction to the set 6090. I don't own even
> > that instruction on paper but only scan downloaded from Internet. The
> > bottom view of part I created is only my imagination how it could
> > look like, taking into account similar parts and some general rules.
> > Could you, please, send me detailed pictures of this part? If it's
> > possible I'd like to see especially scans of the bottom side then I
> > could make necessary corrections. Any advice from you regarding this
> > part will be appreciated too. Please, check it on the Parts Tracker.
> >
> > Regards
> >
> > Marek
>
> It's a little bit risky to make a part only from instruction scans.
> But never mind it's nearly correct. I'll send you a picture from
> the bottom.
>
> CU Bernd
Hello,
I already corrected that part according to Bernd's picture and remarks. Thanks
again, Bernd. Please check the result here
http://www.ldraw.org/cgi-bin/ptdetail.cgi?s=6055
Regards
Marek
|
|
Message is in Reply To:
4 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
