Subject:
|
Re: String and Rope
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 7 Feb 2003 18:34:16 GMT
|
Viewed:
|
1332 times
|
| |
|
|
In lugnet.cad.dat.parts, Karl Asha writes:
> Are there official parts for use in generating string and rope segments? I
> couldn't seem to find anything even after searching through all the
> descriptions.
I do not believe there are. I made an unofficial part for generating black
string. It's not very high fidelity but worked for me.
I could post it if there was interest.
|
|
Message has 2 Replies:
 | | Re: String and Rope
|
| There's a lot of interest from me, if that counts :) Karl Asha karl@blackdown.com ----- Original Message ----- From: "Larry Pieniazek" <lpieniazek@mercator.com> To: <lugnet.cad.dat.part...ugnet.com> Sent: Friday, February 07, 2003 12:34 PM Subject: (...) (22 years ago, 7-Feb-03, to lugnet.cad.dat.parts)
| | | Re: String and Rope
|
| (...) That'd be good if you could Lar. I started working on a string segment with a braid pattern on it, but it didnt work well with the belt generator, and I think it'd be difficult to get one that does without a lot of work. I thought about (...) (22 years ago, 9-Feb-03, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | String and Rope
|
| Are there official parts for use in generating string and rope segments? I couldn't seem to find anything even after searching through all the descriptions. (22 years ago, 7-Feb-03, to lugnet.cad.dat.parts)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
