Subject:
|
New conditional lines in LDView 1.9.4
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sat, 11 May 2002 03:33:01 GMT
|
Viewed:
|
2476 times
|
| |
|
|
If you use the just-released LDView 1.9.4 during part authoring, you might
want to pay attention to the following two new command line options:
-ShowAllType5
-ShowType5ControlPoints
Look in the the new command line section of LDView's help.html file for
instructions on usage.
Putting -ShowAllType5=1 on the command line will cause LDView to display all
line-type 5 lines, as long as you have conditional lines enabled in the
preferences (which are off by default due to performance).
Putting -ShowType5ControlPoints=1 will cause it to draw a line from the
first point of the actual type 5 line to each of the two control points.
These two can be combined if desired, but bear in mind that if you do so, it
will be difficult to separate the control points from the actual lines
themselves.
If you use a launcher program for LDView, and it doesn't allow you to add
command line options, you can create DWORD registry keys of the same names
as the options (without the preceding dash), and set them to 1 in the
following registry path:
HKEY_CURRENT_USER\Software\Travis Cobbs\LDView
Setting these same keys to 0 results in the standard behavior, so you don't
have to delete them to view models normally. You may have to restart LDView
for the registry changes to be noticed, though.
--Travis Cobbs (tcobbs@REMOVE.halibut.com)
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
