Subject:
|
Re: Liftarm width
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Wed, 27 Mar 2002 15:34:27 GMT
|
Viewed:
|
1425 times
|
| |
|
|
In lugnet.cad.dat.parts, Philippe Hurbain wrote:
> Maybe this subject has been beaten to death, but I wonder why straight
> technic liftarms are 20 ldu wide and bent ones are 18 only ?
> In reality both are exactly the same width, which as I measured is close to
> 18 ldu.
Yes, liftarm parts should be 18 LDU wide. Skinny liftarms should be 10
LDU tall, full-liftarms (aka, smooth beams) should be 20 LDU tall.
Steve
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Liftarm width
|
| Maybe this subject has been beaten to death, but I wonder why straight technic liftarms are 20 ldu wide and bent ones are 18 only ? In reality both are exactly the same width, which as I measured is close to 18 ldu. Philo www.philohome.com (23 years ago, 23-Mar-02, to lugnet.cad.dat.parts)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
