 | | 2618.dat Auqanaut Bubble Base (Updated) [DAT]
|
|
Thanks to Carston for his helpful post. For some reason LDDesignPad didn't list any errors. I had to run L3P in DOS mode. Anyway, here's the updated DAT, L3P error free. -Orion 0 Aquanaut Bubble Base 0 Name: 2618.ldr 0 Author: Orion Pobursky 0 (...) (23 years ago, 17-Mar-02, to lugnet.cad.dat.parts)
|
| |
| | Re: 2618.dat Auqanaut Bubble Base (Updated)
|
|
Orion, Can you rotate the part 90 degrees around the X axis? The current orientation is ... unprecedented. :) Steve (...) [snip] (23 years ago, 18-Mar-02, to lugnet.cad.dat.parts)
|
| |
| | Re: 2618.dat Auqanaut Bubble Base (Updated)
|
|
I have another problem with this part, beside the strange rotation angle: The hollow studs at the upper rim should stick out, just as much as normal studs, but they don't. Or is it just me ..? (23 years ago, 18-Mar-02, to lugnet.cad.dat.parts)
|
| |
| | Re: 2618.dat Auqanaut Bubble Base (Updated)
|
|
(...) It's not just you. :) Steve (23 years ago, 18-Mar-02, to lugnet.cad.dat.parts)
|
| |
| | Re: 2618.dat Auqanaut Bubble Base (Updated)
|
|
oh shoot, thanks for pointing that out for me Burkhard. I concentrated so much on getting them in the part, I didn't even notice that they stick above. 2 quick fixes on the way. Also what's the standard for orientation, so I get it right In my next (...) (23 years ago, 18-Mar-02, to lugnet.cad.dat.parts)
|
| |
| | Re: 2618.dat Auqanaut Bubble Base (Updated)
|
|
(...) Generally, parts should be modelled right side up -- ie, in the orientation you would expect to see them in lego building instructions. With studs-up. For parts that don't have an obvious "upright" sense, your best bet is to look at other, (...) (23 years ago, 19-Mar-02, to lugnet.cad.dat.parts)
|
