 | | Re: 6056 - Brick 2 x 2 x 6 with Groove —Steve Bliss
| | | | (...) I haven't looked at the part yet, if you mean one of those underside-studs, such as are found in 1x plates, the hole doesn't need to be there. And if you didn't use the appropriate stud primitive for that part of the part, you should have. (...) (25 years ago, 4-Aug-99, to lugnet.cad.dat.parts)
| | | | | | | | | | Re: 6056 - Brick 2 x 2 x 6 with Groove —Jeff Stembel
| | | | | (...) Good. A stud primitive wouldn't work there because it is only half a stud. If you get a chance to render it, you'll see what I mean. You can also look at part 4216, as it has the same underside. (...) Hmmm... I guess I could go with this then: (...) (25 years ago, 4-Aug-99, to lugnet.cad.dat.parts)
| | | | | | | | | | | | Re: 6056 - Brick 2 x 2 x 6 with Groove —Adam Howard
| | | | | Jeff Stembel <Dragonelf1@aol.com> wrote in message news:FFy9q9.AJF@lugnet.com... (...) underside-studs, (...) if (...) stud. If (...) at (...) I think you should put the hole in. I was going to start work on this after working on another part and I (...) (25 years ago, 5-Aug-99, to lugnet.cad.dat.parts)
| | | | | | |
