 | | Re: 6002, similar to 6909? —Mark Kennedy
|
| | | (...) I haven't seen this part yet, but I have 6059 which is a 3 x 3 x 6 round panel with a spherous top. the problem I discovered was that the top part wasn't a true sphere so I would not be able to use the sphere primitives and the file size would (...) (24 years ago, 13-May-01, to lugnet.cad.dat.parts)
|
| | | |
| | | | | Anybody working on 6909? (Was: 6002, similar to 6909?) —Jacob Sparre Andersen
|
| | | | Mark: (...) Have you - or somebody else - started working on <part:6059>[1]? I could use it (well, actually I have used it) for the building instructions for Katrines bus stop[2]. If nobody else dares to try, then I will give it a try myself. Play (...) (23 years ago, 18-Jul-01, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: Anybody working on 6909? (Was: 6002, similar to 6909?) —Mark Kennedy
|
| | | | (...) part would be a real pain -er- challenge. The non spherical parts shouldn't be too much trouble though. If you or anybody else decides to take it on I wish you the best of luck. (23 years ago, 19-Jul-01, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: Anybody working on 6909? (Was: 6002, similar to 6909?) —Jacob Sparre Andersen
|
| | | | Mark: (...) Ok. I made a rough sketch of it. There are (practically no horizontal lines), the end surfaces are missing, so is the single stud on the top and it is offset 10 LDraw units from its proper origin, but it is enough for me at the moment. (...) (23 years ago, 20-Jul-01, to lugnet.cad.dat.parts)
|
| | | | |
