Subject:
|
Re: tap part number
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Wed, 14 Jul 1999 14:08:22 GMT
|
Viewed:
|
1219 times
|
| |
|
|
The tap base needs edgelines where the handle meets the faucet, and at the
base.
-John Van
Bart Titulaer <b.m.titulaer@phys.tue.nl> wrote in message
news:FEur7M.Fpx@lugnet.com...
> Hi,
>
> Jonathan send me yesterday this unofficial part, I've completed it. Tore
> Eriksson was and is the author (I should have asked you, but I saw it • yesterday
> evening after I had finished it. I thought Jonathan was the original • author), I
> think the knob is completed well now. This part is the top of a two-sub-part
> part, to be combined with the tapbase.dat which I've received also • yesterday,
> perhaps already available on lugnet.com. I send it in the next message.
> Are there already part-numbers available? Are more corrections needed?
>
> Best regards,
>
> Bart
>
> p.s. I only know this combined part in this configuration:
>
> 1 1 0 0 0 1 0 0 0 1 0 0 0 1 tapbase.dat
> 1 7 0 0 0 1 0 0 0 1 0 0 0 1 tap.dat
>
>
|
|
Message is in Reply To:
 | | tap part number [DAT]
|
| Hi, Jonathan send me yesterday this unofficial part, I've completed it. Tore Eriksson was and is the author (I should have asked you, but I saw it yesterday evening after I had finished it. I thought Jonathan was the original author), I think the (...) (25 years ago, 14-Jul-99, to lugnet.cad.dat.parts)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
