Subject:
|
Re: New Part - 3837 Minifig Shovel
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Tue, 13 Feb 2001 10:13:22 GMT
|
Viewed:
|
862 times
|
| |
|
|
In lugnet.cad.dat.parts, Paul Easter writes:
> As requested, here is a Minifig shovel. I based it's center point upon the
> Minifig Pick-axe. If needed I can re-orient this piece.
> As always, I am open for suggestions for corrections, category, keywords, etc.
>
> I tried to use as many primitves as possible for the best POV rendering.
>
> Pictures:
> http://www.geocities.com/pneaster/lego_stuff/3837-01.gif
> http://www.geocities.com/pneaster/lego_stuff/3837-02.gif
>
> Don't dig too much!
>
> Paul
Nice work, Paul. I am not sure I woulf have put in the "edge" where the
cylindrical shaft changes to a conical section, though.
Chris
|
|
Message has 1 Reply:
 | | Re: New Part - 3837 Minifig Shovel
|
| (...) Thanks! If I actually put the "edge" line in after I had returned the part to the parts box. I looked at the shovel again and I agree, it really shouldn't be there. I will remove it and make any other changes needed then I will post it again (...) (24 years ago, 14-Feb-01, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | New Part - 3837 Minifig Shovel [DAT]
|
| As requested, here is a Minifig shovel. I based it's center point upon the Minifig Pick-axe. If needed I can re-orient this piece. As always, I am open for suggestions for corrections, category, keywords, etc. I tried to use as many primitves as (...) (24 years ago, 13-Feb-01, to lugnet.cad.dat.parts)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
