Subject:
|
Re: Fixed Part #2791- added edge ridges
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Mon, 26 Jun 2000 21:28:15 GMT
|
Viewed:
|
1162 times
|
| |
|
|
In lugnet.cad.dat.parts, Steve Bliss writes:
> In lugnet.cad.dat.parts, "Jonathan Gevaryahu"
> 1. Don't use WRITE statements in part files. WRITE (and PRINT) are
> intended for messages to people viewing a final model.
those two lines were left over from when i was editing the model. they
shouldn't be there. oops.
> 2. Should the segments of the sloped surfaces be aligned, or mis-aligned?
> I thought they were a smooth surface, with grooves cut into them. This
> file looks more stepped than smooth.
>
> Steve
yes, they SHOULD be aligned, and I'm working on a slight modification which
will achieve that.
Jonathan Gevaryahu
Jgevaryahu(remove)@hotmail.com
|
|
Message is in Reply To:
 | | Re: Fixed Part #2791- added edge ridges
|
| (...) Yes, if a part-file does have the standard L-CAD header lines, it was written by James. (...) It lookes good. I can't do a hard analysis on it right now -- I don't have one of these parts handy, for comparision. But I'll make a couple of (...) (24 years ago, 26-Jun-00, to lugnet.cad.dat.parts)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
