Special:
|
[DAT] (requires LDraw-compatible viewer)
|
Subject:
|
75.DAT "Technic Flex-System Hose 120LDU Long" (MPD)
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sat, 10 Jun 2000 19:22:28 GMT
|
Viewed:
|
1236 times
|
| |
|
|
These parts have been submitted for voting.
Fredrik
0 FILE 75.DAT
0 Technic Flex-System Hose 120LDU Long (open file for usage guide)
0 Name: 75.DAT
0 Author: Fredrik Glöckner
0 Un-Official Element
0 A Technic Flex-System Hose is typically seen curved in a model. In
0 those cases, some part of the ends are normally fixed inside another
0 element, while the rest of the hose is bent. The parts "76.DAT" are
0 meant to model the straight parts of the hose ends. To achieve this,
0 scale them to have the correct length (ie. 20LDU if they are fixed
0 inside a unit length connector) and place them at the end points. The
0 parts "77.DAT" are meant to model the rest of the hose. If the rest
0 of the hose is curved, you would typically scale the "77.DAT" to a
0 have a short length, eg. 4LDU, and use many of them along the path of
0 the curved hose.
0 In the example below, the end points are scaled to 20LDU length, while
0 the centre part of the hose is scaled to have 80LDU length, thus
0 filling out the rest of the hose.
1 16 -40 1 0 0 -20 0 1 0 0 0 0 1 76.DAT
1 16 40 1 0 0 -80 0 1 0 0 0 0 1 77.DAT
1 16 40 1 0 0 20 0 1 0 0 0 0 -1 76.DAT
0
0 FILE 76.DAT
0 Technic Flex-System Hose End
0 Name: 76.DAT
0 Author: Fredrik Glöckner
0 Un-Official Element
1 16 0 0 0 2 0 0 0 1 0 0 0 2 4-4CYLI.DAT
1 16 0 0 0 4 0 0 0 1 0 0 0 4 4-4CYLI.DAT
1 16 0 1 0 4 0 0 0 1 0 0 0 4 4-4EDGE.DAT
1 16 0 1 0 2 0 0 0 1 0 0 0 2 4-4EDGE.DAT
1 16 0 1 0 2 0 0 0 1 0 0 0 2 RING1.DAT
0
0 FILE 77.DAT
0 Technic Flex-System Hose Segment
0 Name: 77.DAT
0 Author: Fredrik Glöckner
0 Un-Official Element
1 16 0 0 0 2 0 0 0 1 0 0 0 2 4-4CYLI.DAT
1 16 0 0 0 4 0 0 0 1 0 0 0 4 4-4CYLI.DAT
0
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
