To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.dat.partsOpen lugnet.cad.dat.parts in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / LDraw Files / Parts / 117
116  |  118
Subject: 
Re: Un-Official Part: 30358 (SW Landspeeder Engine)
Newsgroups: 
lugnet.cad.dat.parts
Date: 
Tue, 8 Jun 1999 19:15:02 GMT
Viewed: 
996 times
  
Karim,  I don't have this part in front of me, but IIRC the "fins" are angled,
not rounded.  Therefor there should be edgelines where the slope of each fin
changes (at z=20 and z=-20).  Also, I can't tell if there is an edgeline where
the box surrounding the studs intersects one of the fins.

Did you get the stud/slope thing figured out?

-John Van

Karim <knassar@mindspring.com> wrote in message
news:374B7FF4.D57B6060@mindspring.com...
This piece has evolved from a Mock-Up through to its current form, a nearly • completed part.  There
are some problems with it... A couple of lines that should not be there, and • a few that should.  I'm
particularly interested in suggestions on how to treat the inside of the top • box-like area, where
the two studs encounter a double sloped surface... I'm not sure how to solve • that edge-line
condition.

--Karim


0 Name: 30358.DAT
0 Author: Karim Nassar
0 Unofficial Element




Message is in Reply To:
  Un-Official Part: 30358 (SW Landspeeder Engine)  [DAT]
 
This piece has evolved from a Mock-Up through to its current form, a nearly completed part. There are some problems with it... A couple of lines that should not be there, and a few that should. I'm particularly interested in suggestions on how to (...) (25 years ago, 26-May-99, to lugnet.cad.dat.parts)

2 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR