 | | Re: Dinosaur parts
|
|
(...) I began the Tail Section with Pin. CU Bernd (21 years ago, 3-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Dinosaur parts
|
|
(...) The tail sections are in my to-do-bucket. But there are many, many parts with higher priority... /Tore (21 years ago, 2-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Why is the Thickness of Liftarms changing?
|
|
(...) Indeed but... too late now :-( (...) ...but using plates on side of liftarms can be very helpful to stiffen chassis built with them. Philo (21 years ago, 2-Jan-04, to lugnet.cad.dat.parts, FTX)
|
| |
| | Dinosaur parts
|
|
Hi all, is anybody working on these files? Animal Dinosaur Tail Section with Pin (URL) Dinosaur Tail Section End (URL) Dinosaur Head Small (URL) Bernd (21 years ago, 2-Jan-04, to lugnet.cad.dat.parts, lugnet.cad)
|
| |
| | Re: Why is the Thickness of Liftarms changing?
|
|
(...) Thank you for this illustration. I see your point. These parts should have been originally modeled rotated 90 degrees around Z so that the liftarm "thickness" would have been the same a brick "width". I think I can safely say that I have (...) (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: Keyword in description missing
|
|
(...) I'll do it, but first I have to clean up this one: (URL) (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Why is the Thickness of Liftarms changing?
|
|
(...) are several of these liftarms getting changed to 18LDU? (...) Liftarms are narrower than bricks, you don't even need a caliper to see it : (URL) ...and measured with a caliper : brick width: 7.8mm liftarm width: 7.4mm liftarm height: 7.8mm As (...) (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: Keyword in description missing
|
|
(...) I agree. And the Pattern should be rebuild. In the moment it is converted with bmp2dat and so it needs some time to load the part in the preview. Also it doesn't look fine when you zoom in. CU Bernd PS: I don't own the part, so I can't rebuild (...) (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Keyword in description missing
|
|
While we are at it, I think part 3754P01.DAT Brick 1 x 6 x 5 with LL2079 Floating Astronaut Picture should be renamed to Brick 1 x 6 x 5 with LL2079 Floating Astronaut Pattern Jaco (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Why is the Thickness of Liftarms changing?
|
|
(...) I confirm Pauls measurement. I compared it with a brick and it has the same thickness. This is also needed to connect a pin with the holes. CU Bernd (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts)
|
