Subject:
|
Re: Why is the Thickness of Liftarms changing?
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 1 Jan 2004 09:01:27 GMT
|
Viewed:
|
8664 times
|
| |
|
|
Paul Easter wrote:
> In lugnet.cad.dat.parts, Orion Pobursky wrote:
> > In lugnet.cad.dat.parts, Paul Easter wrote:
> > > This part is on the Part Tracker;
> > >
> > > http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/32278.dat
> > >
> > > The 32278 I have has a thickness of .0309" which is approximately
> > > 19.77LDU. Why are several of these liftarms getting changed to
> > > 18LDU?
> > >
> > >
> > > Paul
> >
> > I've measured these and several others have as well and we all got
> > 18 LDU
> >
> > -Orion
>
> What are you using to measure with?
>
> I use a dial caliper.
>
> Paul
I confirm Pauls measurement. I compared it with a brick and it has
the same thickness. This is also needed to connect a pin with the holes.
CU Bernd
|
|
Message is in Reply To:
8 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
