 | | Re: Keyword in description missing
|
|
(...) I'll do it, but first I have to clean up this one: (URL) (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Why is the Thickness of Liftarms changing?
|
|
(...) are several of these liftarms getting changed to 18LDU? (...) Liftarms are narrower than bricks, you don't even need a caliper to see it : (URL) ...and measured with a caliper : brick width: 7.8mm liftarm width: 7.4mm liftarm height: 7.8mm As (...) (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: Keyword in description missing
|
|
(...) I agree. And the Pattern should be rebuild. In the moment it is converted with bmp2dat and so it needs some time to load the part in the preview. Also it doesn't look fine when you zoom in. CU Bernd PS: I don't own the part, so I can't rebuild (...) (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Keyword in description missing
|
|
While we are at it, I think part 3754P01.DAT Brick 1 x 6 x 5 with LL2079 Floating Astronaut Picture should be renamed to Brick 1 x 6 x 5 with LL2079 Floating Astronaut Pattern Jaco (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Why is the Thickness of Liftarms changing?
|
|
(...) I confirm Pauls measurement. I compared it with a brick and it has the same thickness. This is also needed to connect a pin with the holes. CU Bernd (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Why is the Thickness of Liftarms changing?
|
|
(...) What are you using to measure with? I use a dial caliper. Paul (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Why is the Thickness of Liftarms changing?
|
|
(...) I've measured these and several others have as well and we all got 18 LDU -Orion (21 years ago, 1-Jan-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Why is the Thickness of Liftarms changing?
|
|
(...) Yes that seems strange, as far as I can tell all these liftarms are the same width as a 1xN brick, so should be modelled as 20LDU as the bricks are. ROSCO (21 years ago, 31-Dec-03, to lugnet.cad.dat.parts)
|
| |
| | Why is the Thickness of Liftarms changing?
|
|
This part is on the Part Tracker; (URL) 32278 I have has a thickness of .0309" which is approximately 19.77LDU. Why are several of these liftarms getting changed to 18LDU? Paul (21 years ago, 31-Dec-03, to lugnet.cad.dat.parts)
|
| |
| | Re: Keyword in description missing
|
|
(...) OK - I'll make it so. Chris (21 years ago, 28-Dec-03, to lugnet.cad.dat.parts)
|
