 | | Re: New Part: 2706.dat - Technic Action Figure Shoe
|
|
(...) Thanks, Mark. Yes, I know that there have been a lot of new box primitives lately, and someday I will try to learn to use them... :) But so far, it takes much less time to draw all lines by hand then to try to find the optimal primitive. /Tore (21 years ago, 15-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part: 2706.dat - Technic Action Figure Shoe
|
|
(...) Done. Although the file size reduction was trivial (255 bytes) -Orion (21 years ago, 15-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part: 2706.dat - Technic Action Figure Shoe
|
|
(...) I would suggest using the box3u8p primitve on the outside and inside of the shoe to save some space. (21 years ago, 15-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part: 2706.dat - Technic Action Figure Shoe
|
|
(...) Oops, I guess I should visit the PT a little more often... :) /Tore (21 years ago, 14-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | Re: New Part: 2706.dat - Technic Action Figure Shoe
|
|
(...) Tore, I submitted this part to the PT about 3 months ago (URL) also made the lower half of the leg: (URL) Donald Sutter has made the Arm, Hand, Hips, and Upper Leg but we're working together on this so those parts haven't been submitted yet. (...) (21 years ago, 14-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | New Part: 2706.dat - Technic Action Figure Shoe [DAT]
|
|
Is orientation and, most important, distance from centre of joint to top of shoe (12 LDU) ok? It feels a little low maybe, but I have no instruments to measure it exactly. Thanks, /Tore 0 Technic Action Figure Shoe 0 Name: 2706.dat 0 Author: Tore (...) (21 years ago, 14-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | Hold vote on Sticker System with Classic Space Logo Pattern
|
|
hi franklin, (...) (URL) you please be a little more specific about the solid rectangle? thx w. (21 years ago, 9-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | Re: Stud5 and type 5 lines at edge of cylinders.
|
|
(...) Ok, so... that could also mean torii as well... again, the primitive generator and past spreadsheets do this the "old" way. I will have to look into that as well. (...) I believe you are correct. (...) I agree. Should I make this an option on (...) (21 years ago, 8-Oct-03, to lugnet.cad.dat.parts.primitives, FTX)
|
| |
| | Re: 30375csd.dat - Minifig Mechanical SW Droideka (Shortcut)
|
|
(...) it's a complete model. So I suggest a "model tracker". :-) CU Bernd (21 years ago, 6-Oct-03, to lugnet.cad.dat.parts)
|
| |
| | msg to "technog"...
|
|
You have a "hold" vote on this file: (URL) post an image of the gap. Thanks, Franklin (21 years ago, 5-Oct-03, to lugnet.cad, lugnet.cad.dev.org.ldraw, lugnet.cad.dat.parts)
|
