 | | Re: Stud5 and type 5 lines at edge of cylinders.
|
|
(...) Is there a reason that the cylinder primitives haven't been updated to work like the sphere primitive? As long as there are type 5 lines on both ends of each partial cylinder, and the control point out in space is tangent to the cylinder (...) (21 years ago, 17-Aug-03, to lugnet.cad.dat.parts.primitives)
|
| |
| | Re: Stud5 and type 5 lines at edge of cylinders.
|
|
(...) So the problem could be solved by using high res primitives? I'll have to try that out. (21 years ago, 16-Aug-03, to lugnet.cad.dat.parts.primitives)
|
| |
| | Re: Stud5 and type 5 lines at edge of cylinders.
|
|
(...) Ahh, the dreaded S-curve cylinder join rears it's ugly head again. I voted to ignore this a while back and gave my reasons. (URL) disagreed at the time. Don (21 years ago, 15-Aug-03, to lugnet.cad.dat.parts.primitives)
|
| |
| | Stud5 and type 5 lines at edge of cylinders. [DAT]
|
|
I recently reworked the stud 5 primitive to make use of more quarter cylinders. I then noticed that when viewed there were edge lines apearing where they shouldn't. If you look at the primitive from various points you can see this occur. 0 Stud (...) (21 years ago, 15-Aug-03, to lugnet.cad.dat.parts.primitives)
|
| |
| | Re: PT Update Times (Was: 44567)
|
|
(...) Not really. I know what needs to change, I just haven't gotten around to making it happen. Steve (21 years ago, 12-Aug-03, to lugnet.cad.dat.parts)
|
